A brief introduction to the daily maintenance knowledge of the arranging machine

The maintenance of the arranging machine is very important. We cannot rush to maintain the output of the machine. Both humans and machines have a certain load range. Once the load range is exceeded, various problems will occur over time and shorten the service life of the machine. The daily maintenance of the automatic terminal machine can extend the service life and improve the efficiency to a certain extent.

The following is a brief introduction to the daily maintenance knowledge of the automatic wiring machine:

1. The mold fixture must be accurate and firm. The mold gap is reasonable, and the mold edges are always sharp.

2. It is forbidden to overload the machine. For the workpiece to be processed, the punching force must not exceed the limit.

3. Turn on the motor before the clutch must be in the disengaged state and the flywheel is in the idling position.

4. For the lubrication points and friction parts of the machine, please pay attention to add oil on the ground, and add oil no less than 2 times each time.

5. Frequently check whether all parts of the machine are working properly, and whether all chain links and fasteners are loose. If it is loose, please fix it in time. If there is mechanical wear, it must be replaced in time.

1. Preparation before surgery

1. Check whether the machine parts are loose and whether the pneumatic components are leaking.

2. Test run the machine to check whether the machine is operating normally and whether there is any abnormal sound.

3. Turn on the power, check whether the power indication is normal and whether the machine is leaking.

4. Confirm whether the cutting line is consistent with that specified in the job description.

2. Rules of operation

1. Turn on the power and pull the cut wire to the right side of the blade through the wire feed wheel.

2. Set the required specifications (change according to the material number)

3. First cut out one or two for measurement. Check for broken wires.

4. After setting is complete, press the "Start" button to continue.

5. After QC checks and judges that the wire meets the production quality, press "Start" to start production. In the production process, if there is an abnormal situation, please press the emergency stop button immediately and report to the person in charge of the shift (group) or machine maintenance immediately.

6. After cutting the line, turn off the machine, use an air gun to purge the machine table, and do a good job of maintenance when performing "5S" work on the job site.

Shenzhen Tianheng Machinery Co., Ltd. is a Christmas craft gift machine, madder machine, rain silk machine, pine needle machine, automatic drawing machine, drawing machine, glue spreading machine, optical fiber peeling machine, color striping machine, wire arranging machine, rosin The company is headquartered in Longgang District, Shenzhen, and has a complete and scientific quality management system. It is a self-employed professional production and processing of products such as barrel crushers and slitting machine manufacturers. The integrity, strength and product quality of Shenzhen Tianheng Machinery Co., Ltd. have been recognized by the industry. Welcome friends from all walks of life to visit Shenzhen Tianheng Machinery Co., Ltd. for guidance and business negotiation.