How to solve the problem of the arranging machine? Color bar machine

In fact, there are very few problems with the arranging machine. The main reason is that everyone pays more attention to some details when operating the machine. When we are using the fully automatic wire cutting and peeling double-head dipping machine, we should clean up once a day and maintain it once a week. Maintenance is mainly for lubricating slide rails, slide grooves, and sports bearings. Reduce friction and longer service life. Here are the solutions to a few minor problems, I hope to help you all. Color bar machine

 1. There is no tin on the wire port

Check whether the wire opening has penetrated into the tin. If it is immersed in the tin, check whether the wire opening has been immersed in the auxiliary agent. The wire opening is not immersed in the auxiliary agent, and the tin cannot be stained. At this time, the auxiliary agent tank should be adjusted to the position where the wire can be immersed. Color bar machine

Second, the tin furnace does not scrape the tin

Tin ash should be cleaned up once a day. There are differences in the quality of tin, and some tin produces too much tin ash. Will cause the tin scraping to be in place or not to scrape the tin. It's because the tin ash blocked the trip. Therefore, if there is too much tin dust, it should be cleaned up in time. Let the stroke of the scraper clip be unobstructed.

3. Frequently Asked Questions of Wire Stripping Port

1. If there is a broken copper at the stripping port and copper damage, the knife value is too small, and the knife value should be increased.

2. If the wire stripping opening does not open, the knife value is too large, and the knife value should be adjusted down or the opening of the wire pulling manipulator should be too large, so it should be adjusted down.

3. If one side of the line port is normal and the other side is abnormal, the knife is out of balance. Need to be adjusted.

4. There are pinch marks on the line, it means that the manipulator is too tight or the manipulator's mouth is unbalanced.

5. The length of the cutting line is different. The tension of the pulling manipulator is different, and the balance is adjusted.

4. Scrape the tin out of the tin bath when scraping the tin

The reason is that the scraping robot speed is too fast. There is a throttle valve at the end of the tin scraping cylinder to control the air pressure to make it fast or slow.

5. If the machine does not blow air, it is because the solenoid valve or relay does not work properly and rarely fails. The main reason is that everyone pays more attention to some details when operating the machine.

Shenzhen Tianheng Machinery Co., Ltd. is a Christmas craft gift machine, madder machine, rain silk machine, pine needle machine, automatic leaf drawing machine, loosening machine, glue spreading machine, optical fiber peeling machine, color striping machine, wire arranging machine, rosin The company is headquartered in Longgang District, Shenzhen, and has a complete and scientific quality management system. It is a self-employed professional production and processing of products such as barrel crushers and slitting machine manufacturers. The integrity, strength and product quality of Shenzhen Tianheng Machinery Co., Ltd. have been recognized by the industry. Welcome friends from all walks of life to visit Shenzhen Tianheng Machinery Co., Ltd. for guidance and business negotiation.